Tools

Weld Mount bWhite Nylon Wire Tie MountThe AT-3 tie mount is smaller for anel and other small space applications. This part is molded in white nylon and is sized for a #3 wire tie with a maximum width of .20". Average pull strength is about 50 lbs. The...

Sea-Dog Add-A-Snap - Black - 2-1/2" For use with canvas or nylon boat covers, the Add-A-Snap allows you to easily add length on hard to reach snaps from shrunken material. Nickel plated brass/nylon.WARNING: This product can expose you to chemicals...

Weld Mount b1.5" Tall Stainless Stud w/#10 x 24 ThreadUtilize the same base as the 1.4" x 20 studs but with a smaller threaded stud inserted into the base. These studs are ideal for mounting wire clams and securing items which require a smaller stud...

Digital Yacht NAVDoctor NMEA Network Diagnostic ToolNMEA 2000 networks are used extensively for interfacing marine electronic products. It’s based on a robust Canbusarchitecture, but one bad device, cable or termination can have a detrimental...

Weld Mount bWhite Nylon Wire Tie MountThe AT-5 tie mount is designed to be set into wet resin during the hull lay u or bonded with our acrylic adhesives. It's designed for a #5 wire tie and has an average pull strength of 150 lbs. It's approved for...

Weld Mount Stainless Steel Stud 1.25" Base #10 x 24 Thread 2.5" TallStainless stud mounts to virtually any surface using our acrylic adhesive. This is a structural part with 500 lbs of tensile strength and 650 lbs shear strength. Can be bonded from...

Weld Mount bFloating Nut PlatesOur floating nut late is designed for through-hole mounting applications. The rubber fixture holds the part in the through hole while it is bonded in place with our acrylic adhesive. The fixture keeps the threads clean...

Weld Mount bAcrylic Adhesive - 10-PackCAN NOT SHIP AIR,UPS GROUND ONLYAT-2010 is our biggest seller and is a unique adhesive. It has high viscosity and will hold smaller arts without sagging. AT-2010 cures in 5 - 6 minutes, has a 4 minute working time...

Weld Mount Polybonder Kit with AT-880 AdhesiveKit Contains:AT-880 Polybonder Adhesive (1)Dispensing Gun (1)Mixing Tips (qty 10)AT-5W (qty 30)Plano Case Manufacturer : Weld Mount Manufacturer Part No : 88100

Weld Mount AT-880 PolyBonder Adhesive - SingleWeld Mount AT-880 is designed to bond plastics, metals, and rubbers; which have been challenging to bond to, in the past.  AT-880 excels at bonding materials like HDPE, such as King Starboard ™...

Sea-Dog Add-A-Snap - White - 2-1/2" For use with canvas or nylon boat covers, the Add-A-Snap allows you to easily add length on hard to reach snaps from shrunken material. Nickel plated brass/nylon.WARNING: This product can expose you to chemicals...

Weld Mount bStud CoversFor aplications such as engine rooms where our stainless steel studs may be visible, use these press-on white nylon caps to improve the appearance of the installation. The caps are "Matterhorn White". Install the caps before...